Help us:
|
|
|
| | .- |  Written: 2003/01/10 : 12:04. Read 13730 times (-11/day). | When Dodge decides to make a "motorcycle" on the basis of the Viper V10, it gives...
(Automated translation with microsoft BING)
0 votes | |
| |
... a trick my-str-us ...
and likely to leave in production by four years (500 copies) for a sum of 250 to 350 000 USD, according to Wolfgang Bernhard said that the firm will decide this summer.
Say that this project to started on a Dozer between designer one day or a V1Ã suggesting with a tire front and one behind:)
Master kick technique that successfully caser the impressive V10 500cv in machine 2. 59 m long, 70 cm wide and 680kilos... just a little more than the dimensions of the mill...
but is this a motorcycle? Because in there look, this single-seat machine has even four wheels...
They will pair to give a motorcycle look, but there are 4 wheels suspended independently.
Bernhard explained that it was required to support the weight and power of the engine.
When look, precisely, it does not: it does not resemble much of already given. It is huge, gross of trunk, barbaric limit.
Dodge slogan is "take life by the horns." With this machine and its handlebars, this is no longer an image...
scandons in hearts: "glory - engine"
"glory - engine"...
Engine
Here is very far from what you are accustomed to read like the specs for a moto...;)
Well disguised and highlighted by a sompteux brushed alu wrapping, it is block alu V10 to 90 ° and 20 valves of 8277cc of the Viper.
Liquid cooling is provided by a double radiator alu and forced by turbine air intake.
Bore x stroke: 1024 x 1006 mm.
Compression ratio: 9.6: 1
Injection multipoint electronic.
500 HP at 5600 RPM (60 4cv per litre)
71.2 DaN.m to 4200 RPM
Maximum regime: 6000 RPM
Exhaust is provided by a double collector central silencer: the genus 10 pair in 1 2. And ca must make noise...
Between the vilo and the rear wheel, is a box 2-speed assisted clutch (dual disc dry), a 14, a chain sprocket (must be strong that;)) and a Crown of 35...
Ridiculous 12-litre tank enough just to you take to pump in pump... EH Yes, this mill pump almost as kerozene as a viper...
But you y ammenera very very very quickly: it is given to reach 100 km/h in 2.5 seconds, with a theoretical maximum speed of 644 km/h... That said, nobody attempted to check in a real situation.
The "framework" and the "part cycle"
Ben, when a car manufacturer manufactures a motorcycle chassis, it done it: a large carrier engine and a decorative framework alu semblance.
The cycle part little closely resembles everything except a cycle of moto party...
Do you think: no forks and 4-wheel...
The direction is provided by a linkage system that control two suspended wheels independently by a clever system of articulated hinges adjustable for rebound (debattement 57 mm). Two 20 x 4 alu rims are Dunlop P120/60R-20 socks.
The "swingarm" on the back is a piece of steel made by hand, square section, with a monoamortisseur to rods, adjustable for rebound, 57 mm debattement.
Two rims 20 x 5 alu welcome to Dunlop P150/50R-20...
(It will not be given the change of tires train;).
There is even a crutch hydraulics:)
Braking is for the less "suitable".
The front, each wheel receives a ventilated disk périmetrique of 508 mm in stainless steel and each disk has two brackets four specially designed pistons. It goes from or that receive being a blue anodized finish.
At the rear, each wheel receives a ventilated forged cast iron disc and a caliper 4 pistons.
That light be
With a generator that delivers no fewer than 136 amp, the electric circuit is in the luxurious regards illumination:
The front, an optical block to 12 leds from 5 watts to forward, with lens faisseau correctices, follow the direction of the wheels.
A block of 8 leds at the back.
ben then?
Motorcycle?
car was that it removed the body and added a handlebar instead of driving?
nisv? (Unidentified rolling object)
(If you have... s c, Dodge is a motorcycle that would want to push it to its maximum;).
Either way, you can leave your comments in < a href = ".."/forums/viewtopic.php?TopicID = 1248 "> < /a > forums.
(Automated translation with microsoft BING)
|
Please register if you want to write a comment:
Clic here |
|
|
| | |
(not translated yet) Morbidelli : une moto avec un V12
